Bicycle Rear Light Bicycle Rear Light Usb Charging Wireless Remote Control Cycling Warning Signal

Feature:
1. Thanks to the 3 easy-to-use buttons of the wireless controller, the bicycle turn signal can be controlled remotely to send signals in different modes.
2. The bicycle taillight is designed with a wireless remote control, which allows you to easily operate the taillight while riding.
3. There are 4 modes of left-turning light, right-turning light, red LED warning light and SOS flash.
4. The light is bright enough and can be seen in foggy, rainy or dark night, which greatly improves the safety factor of night travel.
5. Easy to install and use, suitable for cycling, stroller, jogging, walking, roadside emergencies and camping.

Specification:

Item Type: Bicycle Tail Light
Material: Plastic
Size: Approx. 11 x 3.5 x 2.5cm / 4.3 x 1.4 x 1 inch
Installation Notes:
1. Pull up the socket of the taillight mounting bracket first and tighten the strap to fix it on the car tube. Then insert the rear light switch upwards into the holder socket.
2. Pull the rubber band of the remote control inward from the bottom around the handlebar of the car, tighten it and secure it.
3. Please keep the charging cable separately.
Instructions:
1. Before use, press and hold the taillight power button for 4-6 seconds to confirm that the button light flashes.
2. Then press and hold the center button on the remote control for 3 seconds to confirm induction connection.
3. The middle button of the remote control can control the red LED indicator on the taillight, and the left and right buttons respectively control the yellow LED direction indicator on the taillight.
Battery and charging instructions:
Tail light:
1. Use the built-in 800mAh polymer lithium battery. When charging, press and hold the top board in the holder to remove the taillight, open the rubber charging port protective cover on the back of the taillight, insert the Micro plug, and use the USB charging cable to load. 2. The charging port red light is on when charging, and the light is green when full.
3. The charging time is 2 hours, and it can be used for 3-4 hours after being fully charged.
4. Note that the battery inside the rear light cannot be replaced by yourself.
Remote control:
1. Use a CR2025 3V button battery.
2. Open the battery cover on the back of the remote control to replace it yourself.

Package List:
1 x Bike Tail Light
1 x Tail Light Mounting Clip
1 x Wireless Remote
2 x Remote Button Battery
1 x USB Charging Cable
1 x User Manual use